🔴 This browser has no Web Serial — use Chrome or Edge on a computer · the USB writer needs its driver (CH340 or PL2303) installed
Write a code to the card (FDX-B 134.2 kHz · EM4305 card)
—
—
Keep the card flat on the writer while writing · afterwards press "Read card" to verify, then hold the card to the reader on the Model T0010-C it must show the same number · the writer builds the FDX-B format itself (no bit calculation needed)
Steps
- Plug in the USB writer (install the CH340/PL2303 driver so it appears as a COM port) · choose model V2 (the unit tested); if the writer does not reply switch to V1 and reconnect
- Press Connect choose the writer port (not the reader port) → place the card → Read card to check communication (a blank card may not read — that is fine)
- Enter country code + tag number → Write to card → must show ✅ · tick "+1" so the next card gets the next number without retyping
This page talks to the134.2 kHz tag writer supplied with the T0010-C reader (original program "Card Writer" · V1 9600 / V2 38400) — the protocol was reverse-engineered from the vendor program because there is no document: read
✅ Tested with the real writer (23 Sep · model V2 38400 · wrote 900/1001 successfully, read back correctly) — if it does not reply try V1 · the T0010-C reader itself cannot write cards; use this writer or a Proxmark3
AA 0F 01 85 8B BB · write AA 0F 0A 84 02 55 + 2 country bytes + 5 tag-number bytes + XOR + BB · write succeeded = byte 4 is 80✅ Tested with the real writer (23 Sep · model V2 38400 · wrote 900/1001 successfully, read back correctly) — if it does not reply try V1 · the T0010-C reader itself cannot write cards; use this writer or a Proxmark3
3D view of the writer
Black ABS box 110 × 80 × 26 mm, USB · place the card in the centre recess while writing/reading · status LED at the top-right corner · once a card is read, the card in the view settles into the recess showing its code
Drag to orbit · scroll to zoom · double-click to reset the view
Drag to orbit · scroll to zoom · double-click to reset the view
Communication log
Write frame to be sent (from the values entered):