This pagewrites to a real drive — Always Read before Write
(Read reports the real size from the drive, no guessing) ·
Peak Current above the motor spec = burnt motor
DisconnectedBaudCOM ID
SETTINGS
Control via
Value
Index
Sub
Size
Set to
Current
PULSE — GEAR RATIO CALCULATOR
Motor (last letter of the model number)Gearbox 1:Signal formatPulse sourcekHz
-
⚡ The first button will read the current values first then asks you to confirm, showing old and new before you decide ·
writing is stillnot permanent until you press Save in the next card and power-cycle the drive
🔴 Check the drive model number first — models FD1X4S-C■-000 and E■-000
have no pulse input pins, no configuration will make them work · the input ceiling on drives that do take pulses is below 500 kHz ·
Motor rated 3000 rpm (the 30 in the model number) ·
Enter A and B at [Pulse] Gear Factor / [Pulse] Gear Divider above
SAVE / REBOOT
⚠️ Disable the motor before Write/Save (some values cannot be written while enabled) ·
recommended: press "Save All" (covers both control loop + motor params) ·
after Save power-cycle the drive (reboot) · Do not press init (=loads defaults, erases your values)
MOTOR TEST RS232 direct to the drive
ModeDIN SimRPM (wheel)GearActual RPM:—
📐 —
⚠️ 24V power required · unit = "wheel revs" (the gear ratio to motor revs is applied for you) · lift the wheels or leave clearance before spinning